X Pole assembly

Watch the video and study the following 14 steps pictorial which show you how to go about safely installing the X Pole in your home. More detailed instructions are also available on the DVD and in the instruction Manual.

Step 1 - Check the contents Remove all the parts from the box, lay them out, identify them and check the contents.	Step 2 - Choose a Pole Dance location Select a pole location, measure the ceiling height and place the base in position.

Step 3 - Choose your extensions Use the height chart to select any extensions (if required).	Step 4 - Locate the ceiling joists Locate the ceiling joists by tapping with a finger or using a stud/joist locator. Put the base in position below the joist or joists you are going to use.

Step 5 - Fit the extensions to the base (if required) Attach any extensions to base insert. Extensions always fit at the bottom of the pole smallest first.	Step 6 - Attach lower main pole. Screw the lower main pole onto the extension or base insert. Tighten firmly by hand.

Step 7 - Fit adjuster cover Slide adjuster cover into position just covering the O-ring.	Step 8 - Attach the Upper Dome Slide the upper dome onto adjuster shaft. X Pole uses a long adjuster shaft with 3 bearings to lock the dome at 90 degrees to the Pole.

Step 9 - Fit the pole tubes together Attach upper pole assembly to lower pole. Screw up tightly and hold vertical.	Step 10 - Tighten Adjuster Unscrew the adjuster by hand until it is firm against the ceiling. Make sure the upper dome is flat.

Step 11 - Tighten the tubes Tighten the pole sections firmly but not over tight.	Step 12 - Final check Tighten pole adjuster with spanner or rod until it is really firm. Check for movement and retighten if there is any movement.

Step 13 - Fit adjuster Cover Slide the adjuster cover up, press in the two sprung pins and lock in place	Step 14 - Ready to go! After a final check for movement X Pole is ready for use. Where ever it's used X Pole is up and ready for action in minutes.